| « Scalextric Trans AM practice | Monogram Grand Nationals Regional » |
Scalextric Vintage Trans AM Regional
04/15/12, Sunday – Scalextric Trans AM Regional
Results;
Dutch C. 257 laps
Hugh H. 254 laps
Bob K. 253 laps
Bill G. 241 laps
Joe R. Sr. 238 laps
John R. 234 laps
Lawerence J. 216 laps
Sunday - Race starts at 2:00 PM
-Running Voltage: 12V DC
-Running Track: Scalextric
-Fuel Management: No.
-Cars Allowed: ’69-’73 Camaro/’69-‘71 Mustang – all sidewinders.
-Chassis: Modifications allowed (per Nationals rules) to allow body float. Sharp edges and burrs may be trimmed or sanded slightly only to permit clearance for the proper seating of the body onto the chassis.
-Body: Modifications allowed (per Nationals’ rules) to allow body float. Sharp edges and burrs may be trimmed or sanded slightly only to permit clearance for the proper seating of the body onto the chassis. If body screws are run loose, tape must be placed over the holes in bottom of chassis. Must use all 6 screws. Windows must remain transparent. The complete interior must be used and no modification or lightening is allowed. Custom paint allowed, must have interior.
-Gears: 12t 6.5mm Slot.It sidewinder pinion gear and any available Slot.It 19mm sidewinder spur gear.
-Bushings: Scalextric or Slot.it allowed. Cannot alter the stock bearing location in the chassis. Bearings can be glued into place.
-Wheels/Axle: Stock Scalextric or Slot.It wheels and tires are allowed on the front of the car, and any Slot.It 15.8/16.5/17.3mm by 8.2mm aluminum or magnesium wheels will be permitted front and rear. (Note: 14.3/14.4 mm wheels are not permitted.).
-Tires: Front tires stock may be sanded or Slot.it zero grips. Rear tires Slot.it S1 or S2 only. Tires will not be supplied. No tire treatments allowed.
-Electrical: Motor noise filters not required.
-Magnet: No magnets.
-Motor: Slot.it Orange endbell 21.5K motor. Motor must have undamaged metal tabs. Cutting the shafts are allowed. Motors are not supplied. No chemical additives to the motor (ex: voodoo drops) or other motor modifications allowed.
-Weight: Additional weight allowed, interior only.
-Vehicle Ground Clearance: Body or gear cannot touch the track.
-Wire: Any 1/32 wire leads allowed.
-Guide Blade: Scalextric or Slot.it. Shims allowed and any 1/32 braid allowed. No chemical additives to the braids (ex: voodoo drops).
If you are not a store member, race fee is $10.00 and includes practice time.
Link to national rules; http://www.gtslots.com/final2012-sclx-transam.php
If it does not indicate above that it's allowed, it's not allowed
-House rules apply.


